Speck pumpen BADU Jet Smart KH, Operating And Installation Instruction

Page: 34 / 66

34
07.03.2014 TB-b bta badu jet smart_engl.indd
Press knob gasket (26) into jet housing (1) and place against
the back of the pool wall.
Fix the jet housing from the front with ten self-tapping screws
(52) through clamping ring (28) and clamping ring gasket (27) to
the pool wall.
Attention: Tighten the self-tapping screws only by hand.
Do not use force.
Fitting of the jet housing in polyester pools
ATTENTION:
The jet housing is made of ABS. If the suction and pressure
tubes are to be glued into the housing when the housing
is already in place, a minimum hardening time of 12 hours
must be observed.
bta badu jet smart_engl.indd 34 10.03.2014 09:31:01