Specialized Turbo Creo SL Comp E5, Service & Repair Workbook

Page: 64 / 67

WORKSHOP PREP FOR RIDER HANDOVER (CREO CAN BE HANDED TO RIDER AFTER THIS)
THIS BIKE PREP CHECKLIST IMPLIES A CREO HAS ALREADY BEEN BUILT TO BE FULLY RIDEABLE:
1. PLACE BIKE IN WORKSTAND
2. GET SOFT CASE WITH DOCUMENTS, CHARGER AND SMALL PARTS FOR BIKE
•
ENSURE IT IS THE CORRECT CASE/PARTS (PEEL ME STICKER W/ MATCHING WSBC IS APPLIED ON LAST PAGE OF CREO MANUAL)
3. MOUNT RANGE EXTENDER, IF REQUIRED (ZEE CAGE, 220 MM RE CABLE, RETENTION STRAP)
4. CHECK FOR FIRMWARE UPDATES
•
UNSCREW TCU, CONNECT IT TO PC VIA USB CABLE, TURN TCU ON, START TURBO STUDIO, CHECK FOR FW UPDATES AND RUN THEM
• ADJUST WHEEL CIRCUMFERENCE IF STANDARD TIRES GOT REPLACED
•
DISCONNECT USB CABLE, SEAL PORT, RE-INSTALL TCU (0.8NM MAX.)
5. RUN FUNCTIONAL CHECK OF E-BIKE FUNCTIONALITY
• TURN TCU ON, MAKING SURE START-UP BEHAVIOR IS NORMAL (IF TCU SHOWS ERROR MESSAGES, FOLLOW TROUBLESHOOTING GUIDE)
•
MAKE SURE MOTOR SUPPORTS (USE TURBO MODE FOR EASY RECOGNITION)
• CYCLE MODES
•
CONNECT WITH MISSION CONTROL USING PAIRING CODE, START ‘TUNE’ TO VERIFY THAT MODES ARE SET TO DEFAULT (35/35 – 60/60 – 100/100)
6. MOUNT/ADJUST ALL ACCESSORIES (PAIR TCD, SET CLOCK, ETC.)
7. CHECK/ADJUST ALL STANDARD FUNCTIONALITY (BRAKES, SHIFTING, DROPPER POST, BOLT TORQUES, TIRE PRESSURE, ETC.)
8. TEST-RIDE CREO
•
CHECK ALL FUNCTIONALITY, ELECTRONIC AND NON-ELECTRONIC
•
USE ALL MODES
•
BED THE BRAKES IN BY BRAKING 10-15 TIMES TO ALMOST STANDSTILL
9. FULLY RE-CHARGE CREO BATTERIES AND DI2 BATTERIES
10. MATCH BIKE AND SOFT CASE (CONTAINS ALL DOCUMENTS, CHARGER AND SMALL PARTS)
CREO SL: BIKE PREP FOR RIDER HANDOVER