Specialized Turbo Creo SL Comp E5, Service & Repair Workbook

Page: 31 / 67

CREO SL: REPLACING CHARGE PORT COVER & MAIN HARNESS
3
1
4
2
REPLACING CHARGE PORT AND MAIN HARNESS: QUICK GUIDES
•
CHARGE PORT COVER W/LID AND MAIN HARNESS ARE SEPARATE PARTS (SEE
SERVICE PART LIST & SERVICE WEBSITE)
• REPLACING THE CHARGE PORT W/LID DOES NOT REQUIRE MOTOR REMOVAL
•
REPLACING THE MAIN HARNESS REQUIRES MOTOR REMOVAL
REPLACING THE CHARGE PORT W/LID (TX 8)
• POWER BIKE OFF
•
REMOVE RE IF INSTALLED
•
OPEN LID, THEN ONLY REMOVE 3 SCREWS (1-3)
•
LOOSEN UPPER RIGHT SCREW (4) TILL YOU CAN ROTATE UP CHARGE PORT
• ATTACH NEW CHARGE PORT WITH UPPER LEFT SCREW (3)
• REMOVE OLD CHARGE PORT BY REMOVING SCREW (4)
•
ROTATE NEW CHARGE PORT INTO POSITION
•
RE-ATTACHED ALL REMAINING SCREWS, CAREFULLY TIGHTEN HAND-TIGHT
•
SHOULD HOLES SLIGHTLY MISALIGN, YOU CAN MOVE THE MAIN HARNESS INTO PLACE BY
USING YOUR HAND TO CAREFULLY PULL ON CONNECTOR INSIDE FRAME