11
7.3. INSTALLATION
B
A
7.3.1
C
7.3.2
Twist to install the display onto the display mount, then fasten the anti-twist plate (fig 7.3.1 a) with the small
screw (fig 7.3.1 b). Recommended torque is 4.4 in-lbf / 0.5 Nm.
Remove the components from the side of the handlebar intended for the installation of the display mount, it can
be installed on the right or left side of the stem.
Tighten until the mount does not slip easily (fig 7.3.2 C). Do not overtighten. Recommended torque is 4.4 in-lbf
/ 0.5 Nm.
7.4. BATTERY ACTIVATION / REPLACEMENT
7.4.1
7.4.2
Use a flat head screwdriver to lift up the edge of the battery cap (fig 7.4.1), then gently lift the battery out of the
cap.
Replace the battery with a new CR 1220 coin cell battery, with the text facing the cap (fig 7.4.2). Make sure the
seal is not damaged and press the cap back in.
When the battery is replaced, all information stored on the display (time, trips, and pairing) is erased. If desired,
take note of the information before replacing the battery.
The USB port is only for use by retailers or service centers.
