CANVAS FITTING INTERFACE METHOD (2 piece system)
If the 3D Modular System has been set up to interface on the existing wheelchair canvases
then the following method is used to install and remove it from the wheelchair.
Whilst
•
holding the cushion of the 3D Modular System, place this into the wheelchair
making sure that the front bar on the support frame (if fitted) locates behind the
armrest upright posts (Fig.1.1a) or into the ski brackets (if fitted).
Having
•
located the cushion into the wheelchair, Place the 3D Modular backrest into
the wheelchair on top of the cushion and up against the rear canvass.
Once
•
the backrest is in position on the cushion the seat retention straps now need
to be fastened around the back of the wheelchair (Do Not fasten the securing straps
before the two pieces are in the wheelchair).
There
•
are 3 retaining straps (Fig.1.1d) to secure around the wheelchair on the 2 piece
3D Modular System.
Seat
•
Retention Straps are secured around the back of the wheelchair frame, not just
the wheelchair canvas (Fig.1.1b).
With
•
the 3D Modular System now installed into the wheelchair it is now safe to place
the client in position.
SOS
•
Seating Systems need to be interfaced to the wheelchair safely and it is
important that the retention straps are always secured for client safety.
Removing
•
the 3D Modular System from the wheelchair is the reverse of the above
procedure.
11
1
2
Fig.1.1c
1
2
3
Fig.1.1d
