17
USER GUIDE 3.0
MAINTENANCE
OF THE 3D MODULAR SYSTEM
To
make sure that the 3D Modular System remains satisfactory it is necessary to carry out
simple maintenance.
3.1. CLEANING THE 3D MODULAR SYSTEM
During
•
use the 3D Modular System will require cleaning. This can be done by simply
applying a warm damp cloth with a mild detergent to the inside surface of the seat to
remove any soiling and towel dry.
Note:
The covers/pads
MUST
be removed prior to
any cleaning of the seat.
If
•
the 3D Modular System remains slightly damp simply leave for a short period at
room temperature to dry.
The
•
moulded foams are sealed in a special water proof clear plastic protective skin
which although waterproof is air permeable to assist daily management. Under no
circumstances is the clear protective skin to be removed as the foam will have no
protection against contamination and will need to be replaced. If the plastic skin
becomes seriously damaged contact SOS immediately. To clean the moulded pads,
simply wipe down with mild detergent and a damp cloth and towel dry and leave at
room temperature to dry thoroughly. Under no circumstances use excessive heat to try
to dry the foam as this could damage the protective skin.
The
•
ancillary Foam pads on the 3D Modular System can also be made from an open
cell foam, which will absorb water.
DO NOT
get these excessively wet as the foam will
be a problem to dry.
DO
•
NOT PUT THE 3D MODULAR SYSTEM NEXT TO A HOT FIRE OR USE
EXCESSIVE HEAT TO DRY AS EXCESSIVE HEAT COULD AFFECT THE
COMPONENTS OF THE SEAT.
DO
•
NOT USE SCOURERS OR CAUSTIC SUBSTANCES SUCH AS BLEACH
