TWIGA CLASSIC S50
14
4. Raise machine to required height.
Both P.T.O. shafts should be roughly
in-line, an upward angle of up to 17° is
acceptable to ensure adequate
clearance.
5. Adjust the top link so that the
machine sits vertically.
6. Fit locking pins to stabiliser tubes,
then the linkage can be lowered so
that the weight of the machine is taken
by the stabilisers. It is essential that
both tubes are set to equal lengths,
more than one attempt may be
required to achieve the correct height
as the machine settles on the
stabilisers.
