Spearhead
Multicut
460
11
Setting Up Your Machine
Height
To alter the minimum height of cut; fully raise the machine, remove pin
a
(Fig. 4) slide
sleeve
b
forward or backwards to raise and lower cutting height respectively, replace
pin
a
through sleeve
b
and gently lower the machine. The sleeve
b
only controls the
minimum cutting height, however the operator may raise and lower the machine by
the hydraulic ram when the machine is in operation.
Use the height gauge as a guide when setting height of cut
Wings
Unfolding the wings if the machine is in the transport position, first pressurise
hydraulic rams before releasing locking pins, lower both wings by releasing hydraulic
pressure, leaving tractor spool in float position (Fig, 5).
The screw adjustment on the wing ram mounting point enables the transport width to
be minimised when the wings are raised. Ensure wing rams are fully closed before
lengthening adjusting bolt to reduce transport width.
