Spearhead AGRICUT
240 Offset
29
Machine Operation
Operating the Machine
Upon arrival at the location to be topped, lower the machine fully so that both skids are
sat on the ground.
o
Lift the machine so it clears the ground by approximately 100mm then gently
engage the PTO and run at tick-over speed.
o
Lower the machine to the ground, and increase the PTO speed to 540 rpm.
o
Select a forward speed that is suitable for the ground conditions and the type of
material to be cut.
o
Check the machine is ‘floating’ correctly. Ensure on Agricut 240 Offset models
that the top link is attached with its pin in the slotted hole on the headstock to
allow better flotation.
NOTE: When turning at headlands, lift the machine so the skids just clear the
ground. This will reduce field damage in wet conditions.
o
If the stubble height is not correct, adjust the skid height accordingly
–
refer to
‘Machine Setting and Adjustments’.
Stopping the Machine
When stopping the machine, use the following procedure:
o
Reduce forward speed and bring the tractor to a halt.
o
Keep the machine lowered onto the ground.
o
Reduce engine revs to idle speed, and disengage to PTO.
o
When the rotor has stopped turning, raise the machine to the transport.
240 offset models only
; ensure top link is
located and secured by pin in slotted hole on
headstock.
