Spear & Jackson S2655HP, Instruction Manual

Page: 27 / 29

26 AFTER SALES SUPPORT 0345 605 2070
TROUBLESHOOTING
Fault Possible Cause Solution
1. Engine does not start 1.1 Not enough petrol in fuel
tank 1.1 Add petrol
1.2 Primer has been not
pressed at cold start 1.2 Press the primer and
restart
1.3 Primer has been pressed
at warm start 1.3 Dry spark plug
1.4 Spark plug is wet 1.4 Dry spark plug
1.5 Spark plug is damaged 1.5 Replace spark plug
1.6 Spark plug connector
lose
1.6 Attach properly
1.7 Ignition switch is not
switched on 1.7 Set ignition switch to “I”
1.8 Choke button position is
wrong 1.8 Set the choke lever
position correctly as the
starting steps
2. Engine stops 2.1 Not enough petrol in the
fuel tank 2.1 Add petrol in to fuel tank
2.2 Cutting device is blocked 2.2 Remove blockage
2.3 Cold machine does not
warmup
2.3 Let the engine warm up
at idle for a while
2.4 Not enough oil or wrong
oil 2.4 Add the 4 stroke engine
oil to the full level of oil tank
3. Unsatisfactory cutting
performance 3.1 Cutting blade is dull/
damaged 3.1 Have a specialist to
sharpen or replace it
3.2 Cutting material exceeds
capacity 3.2 Only cut materials
according to
the capacity of the product
4. Excessive vibration / noise
or exhaust 4.1 Cutting device is dull/
damaged 4.1 Replace with a new one
4.2 Bolts/nuts are loosen 4.2 Tighten bolts/nuts
4.3 Petrol/oil is incorrect 4.3 Empty unused petrol/ oil
and refill with the correct
petrol/oil