USER’S MANUAL
EN
17
4.
Liquid cooled MIG gun: connect the end of liquid hose
(hot water)
to coupler
19
.
5.
Liquid cooled MIG gun: connect the end of liquid hose
(cold water)
to coupler
20
.
7.5.5 Assembling welding wire into liner
1.
Connect properly MIG gun into welding machine
(see 7.5.4).
2.
Dismantle the torch consumables
(gas nozzle, contact tip)
.
3.
Connect the welder into power supply. Turn on the machine using power switch
10
.
4.
Expand MIG gun as straight as it is possible.
5.
Using the button INCH FEEDING – on the wire feeder control panel, start wire feeding into
MIG gun liner. Make sure that pressure tension of feeder rolls is suitable. Remember! Never
point torch into direction eyes / face or others.
6.
When wire end comes out to a distance approx. 30mm beyond the torch outline, release
the button INCH FEEDING.
7.
Assemble welding wire into liner
(gas nozzle, contact tip)
.
8.
Cut off the end of wire properly.
7.5.6 Device installation
1.
Connect connection cable (
see 7.5.2).
2.
Connect MIG/MAG gun into device
(see 7.5.4)
.
3.
Connect return cable into SK socket „-”
9
and the earth clamp into workpiece.
4.
Ensure that all threaded connections do not have any slack, and gas connection is tight.
5.
Connect the welder into power supply in accordance with appropriate guidelines
(see 7.5).
6.
Turn on the device by setting the switch
10
to ON position.
7.
Assemble welding wire into liner
(see 7.5.5)
.
8.
Open valve in the gas cylinder and set appropriate value of shielding gas flow, use the switch
8
on the front of the source device.
9.
Device is ready to weld.
Gas cylinder
Weld material
Gas heater
connection
Input
400V AC
Wire feeder
Connection cable
Pressure regulator
Control cable
MIG/MAG gun
