USER’S MANUAL
EN
8
Welding and plasma cutting processes may emit additional interferences. User is
responsibility for the interferences caused by welding and plasma cutting.
3.2 ASSESMENT OF AREA
Before installing arc welding equipment, the user shall make an assessment of potential elec-
tromagnetic interferences in the surrounding area. The following shall be taken into account:
a) other supply cables, control cables, signaling and telephone cables, above, below and adja-
cent to the arc welding equipment,
b) radio and television transmitters and receivers,
c) computer and other control equipment,
d) safety critical equipment, for example guarding of industrial equipment,
e) the health of the people around, for example the use of pacemakers and hearing aids,
f) equipment used for calibration or measurement,
g) the immunity of other equipment in the environment. The user shall ensure that other equi-
pment being used in the environment is compatible. This may require additional protection
measures.
h) the time of day that welding or other activities are to be carried out.
The size of the surrounding area to be considered will depend on the structure of the building
and other activities that are taking place. The surrounding area may extend beyond the boun-
daries of the premises.
3.3 METHODS OF REDUCING EMMISIONS
Methods of reducing electromagnetic interference are listed in detail in the standard
EN 60974-9 – „Arc welding equipment – Part 9: Installation and use”.
4. CONFORMITY WITH STANDARDS
The SPARTUS
®
ProMIG 420H / SPARTUS
®
ProMIG 420HW is in conformity with the relevant Union
harmonization legislation:
LVD 2014/35/UE
Low Voltage Directive
EMC 2014/30/UE
Electromagnetic Compatibility Directive
harmonized standards:
EN 60974-1
Arc Welding Equipment
– Part 1: Welding Power Sources
EN 60974-10
Arc Welding Equipment
– Part 10: Electromagnetic Compatibility
Requirements
4.1 CE MARKING
CE
marking is placed on the nameplate of device and/or on the front panel of device.
