SR100 REMOTE CONTROL CAR ALARM SYSTEM
18
INDICATOR OUTPUT
When the alarm is activated
Wiring fault or fuse blown in harness
indicators do not flash.
Check wiring and replace any blown
fuses.
STARTER INHIBIT NOT WORKING
When PINK wire is connected to a 12V ignition controlled supply in the START and
RUN position of the ignition switch.
CAR WILL NOT START
Check the connections to the ORANGE and BROWN immobiliser wires.
If none of the above solutions solve the problem either consult your dealer, or
contact the Sparkrite Technical and After Sales Service (T.A.S.S.) on 01429 862616.
ALARM GIVES FALSE ALARMS
Check position of Valet Switch and Reset using Enable/Disable sequence.
Bad Earth of Supply Connection.
Check connection of BLACK earth wire.
Check connection of RED supply wire.
Post Ignition.
Check that your vehicle does not
have any electrical circuit operating
when the vehicle is parked, i.e.
Hazard lights, radiator cooling fan,
etc.
Shock Sensor too Sensitive.
Check and re-adjust shock sensor.
Current Sensing too Sensitive.
Decrease trigger sensitivity by
relocating RED wire to an alternative
12V position closer to the battery.
Wiring Fault
Test operation of all switches and
ensure all triggering connection are
secure and make good electrical
contact.
