SR100 REMOTE CONTROL CAR ALARM SYSTEM
16
Installing the Waterproof Rubber Boot
To protect the alarm from water ingress, the rubber boot must be finally installed
using Silicone Sealant (supplied) and should be applied as follows:
CAUTION:
Uncured sealant irritates eyes. In case of contact wash with water and consult your
doctor.
Avoid prolonged skin contact. Acetic acid fumes are released during curing, ensure
adequate ventilation is provided.
Firstly, clean all surfaces thoroughly. Apply a thin even bead of silicone around the
outer lip of the back alarm moulding, The remaining silicone will now be applied
down the narrow section of the rubber boot. The silicone should be worked between
and around the wires ensuring ample coverage. Once the silicone is in place a tie
wrap (supplied) should be fastened around the narrow section of the rubber boot.
The tie wrap will force part of the silicone back out of the rubber boot, this excess
should NOT be wiped/cleaned away, but worked back into the boot.
The silicone sealant will be fully cured after 24 hours.
Complete the installation by neatly securing the ultrasonic unit and alarm wiring
harness using tie wraps and/or insulation tape.
WARNING: Failure to carry out these instructions will result in water ingress, false
alarms and will invalidate any warranty claim.
Complete the instillation by neatly securing the ultrasonic unit and the alarm wiring
harness.
