SpacePak ESPV2-109, Installation, Operation & Maintenance Manual, Page: 14 / 28

14
PLENUM
FASTENER
GASKET
PLENUM TAKE-OFF
GASKET
PLENUM TAKE-OFF
PLENUM
FASTENER
1. HAND INSERT FASTENER INTO PLENUM TAKE-OFF 2. WITH PLIERS, SNAP FASTENER INTO PLACE.
MAKE SURE IT IS FULLY SEATED
FIGURE 2.22: PLENUM TAKE-OFF FASTENER INSTALLATION
PLENUM
GASKET
FIGURE 2.21: TAKE-OFF INSTALLATION
FIGURE 2.23: ORIFICE INSTALLATION
Remove the hole cut-out from the plenum. Make sure
there is no “flap” left inside plenum that could block hole
during operation.
Place the plenum take-off gasket on the back side of the
plenum take-off and insert the assembly into the hole in
the plenum (see Figure 2.21).
NOTICE: Gasket must be installed to seal plenum
take-off to prevent air leakage.
Orient the plenum take-off to match the curvature of the
plenum duct. Hand insert the four plenum take off
fasteners one at a time such that each clip reaches the
interior of the duct. Using the SpacePak pliers, snap the
fasteners into place until they lock in place (see Figure
2.22).
NOTICE: All four fasteners must be installed to
assure an air tight fitting between plenum take-off
and plenum.
In accordance with your calculations as to requirements
for balancing orifices, mount the orifice in the outlet of the
plenum take-off (see Figure 2.23), prior to attaching the
supply tubing.
Next, install a kwik-connect in the open end of the supply
tubing, using the same procedures as before, and twist
together kwik-connects on supply tubing and plenum
take-off. Wrap connection securely with tape.
FIGURE 2.19: CONNECTING TUBING