www.spacemanusa.com
Phone: (720) 328-1020
Email: [email protected]
1. Turn power switch to OFF
2. Remove hopper lid and agitator (if present)
3. Place a bucket or other container below draw
valve to capture product as it drains
4. Turn power switch to WASH
5. Move draw handle to OPEN position (RIGHT)
until all product runs out
6. Move draw handle to CLOSED position (LEFT)
7. Turn power switch to OFF
8. Remove product and dispose or refrigerate it
9. Fill hopper with a minimum of 2 gallons of
COOL water
10. Use COOL water and the large brush to scrub the
sides and bottom of the hopper; be VERY careful not
to damage the low
-
mix sensor in the hopper
11. Use the small brush kit to clean inside the feed tube
at the bottom of the hopper
12. Place a bucket or other container below the draw
valve
13. Turn power switch to WASH
14. OPEN draw handle to drain water and remaining
product; CLOSE when finished
15. Turn power switch to OFF
16. Repeat steps 9 to 14 until water exiting the draw
valve is clear and free of product
1
14
2
3
7
8
9
12
4
13
10
15
16
5
6
Cleaning: 1. Drain Product
8
NOTES: To expedite draining, turn off machine 30 minutes prior to soften product.
To expedite process, keep a bucket nearby to temporarily store removed parts.
CAUTION: Never use warm water when rinsing the machine to prevent damage.
11