www.spacemanusa.com
Phone: (720) 328-1020
Email: [email protected]
Freeze product
1. Verify cylinder is full of mixed product
2. Turn power switch to FREEZE and verify
STANDBY mode is off (see below)
3. The motor will begin to agitate the
product, and the cooling system will
begin to freeze the product
4. Freezing product takes approximately 10
minutes; product is at the adjusted
viscosity when the flat sensor arm is
switched to the RIGHT
5. When the product reaches the desired
viscosity, it is ready to dispense
Dispense product
1. OPEN draw handle (RIGHT) until the desired
amount is dispensed
2. CLOSE the draw handle (LEFT) when finished
dispensing
CLOSED
OPEN
15
Frozen Product Operation
IMPORTANT: When the machine will NOT be
utilized for several hours, place it in STANDBY
mode to conserve electricity and reduce
product loss.
In STANDBY, product remains below 41
o
F in
both the cylinder and hopper, but will NOT be
frozen.
To exit STANDBY mode:
Press STANDBY indicator light on front of
machine, and green light will de-illuminate.
Allow 5 to 10 minutes for machine to begin
freezing again.
To enter STANDBY mode:
Press STANDBY indicator light on front of
machine.
Light illuminates green when machine is in
STANDBY mode.
NOTE: If machine doesn’t turn on, turn power switch OFF, wait
30 minutes, and repeat steps 1 to 4. If problem persists, contact
service team.
CAUTION: If machine makes any abnormal noise during reset,
immediately turn power switch OFF and contact service team.
IMPORTANT: Machine shuts
down automatically if
cylinder experiences freeze-
up (usually because the
viscosity is set too high for
the selected product to
prevent motor damage.
Use the green reset button
on the machine’s back panel
to return the machine to
normal operation.
Proper Machine Reset
1. Turn power switch to OFF
2. Firmly press green reset button
3. Wait 15 to 20 minutes.
4. Turn power switch to WASH
5. Observe machine performance
Machine power reset
Standby mode