
Quick Installation Guide
21
SY-6BB
Warning: Follow these precautions to preserve your motherboard
from any remnant currents when connecting to ATX power supply:
Turn off the power supply and unplug the power cord
of the ATX power supply before connecting to ATX PW
connector.
This motherboard requires a power supply with at least 200 Watts
and a "power good" signal. Make sure the ATX power supply can
take at least 10mAmp load on the 5V Standby lead (5VSB) to meet
the standard ATX specification.
Note on KB Wake-Up Function Power Requirements: If you
are using the KB Wake-Up Function with 5VSB, make sure
your power supply can provide 100mAmp or higher current.
Install the ATX power according to the following pin assignment:
Ø
Pay special care to the directionality.
Ø
Make sure pin 1 is in its position.
3.3V
3.3V
GND
5V
GND
5V
GND
PW-0K
5VSB
12V
ATX Power
3.3V
-12V
GND
PS-ON
GND
GND
GND
-5V
5V
5V
Summary of Contents for SY-6BB
Page 70: ...Appendix Quick Start Guide...