5
2. Assemble Components
1. Lay out cross beam in a cleared area. Place one A-
frame at either end of the cross beam as shown.
2. Lift one side of cross beam onto A-frame and line
up outside bolt hole on A-frame with desired bolt
hole on cross beam. Place bolt through bolt hole on
A-frame and cross beam with washers on either
side of the bolt. Loosely tighten so A-frame can
swivel when A-frame is erected.
3. Place trolley at the opposite end of the cross beam.
Center trolley on cross beam and tighten with set
screw.
4. Lift cross beam end without bolt inserted and
position on A-frame lining up outside bolt hole on
A-frame with desired bolt hole on cross beam.
5. Place bolt through bolt hole on A-frame and cross
beam with washers on either side of the bolt.
Loosely tighten so A-frame can swivel when A-
frame is erected.
6. Erect one A-frame and line up inside bolt hole on
the A-frame with corresponding bolt hole on the
cross beam. Using a ladder, place bolt through bolt
hole on A-frame and cross beam. Tighten both sets
of bolts.
CAUTION
Be certain both casters on both A-
frames are locked before erecting
A-frames.
