12
11
SET UP AND OPERATION
SET UP AND OPERATION
CONDUIT ADAPTORS
1. To attach conduit adaptors to the cart, slide the adaptor plate
into the mounting slot on the back of the cart. Pull spring
locking fasteners for easy storage and removal of conduit
adaptors. Compatible with both Maxis
®
3K and Maxis
®
6K.
Be sure to store 1” and 1-1/2” conduit adaptors in the tool
bag when utilizing the Maxis
®
3K adaptors.
PUTTING PULLER TOGETHER
1. Always wear gloves, eye protection, hard hats and safety
toed shoes when working with pullers.
2. Remove gearbox assembly from cart and lay on the ground.
3. Lay front extension assembly face down; remove clevis pins
on extension assembly.
4. Slide 2” outer sleeve over gearbox assembly and reinstall
clevis pin (Fig 1).
5. Slide drill in place over drill chuck adaptor and tighten all
three holes of the chuck, (if this is not done the drill may slip
on the shaft) Do not tighten just one chuck hole (Fig 2-3).
6. Secure drill in place with drill mount bolt (Fig 4).
7. Maxis
®
3K was designed to be used with the Milwaukee
Super Hawg
®
drill.
8. Set the motor to the desired speed, H or L (Fig 5).
ATTACHING THE CONDUIT ADAPTORS
1. Remove 4- 1⁄2” x 1⁄2” hitch pin on front extension (not the
pin with the roller), swing front extension forward and install
conduit adapter (size 2, 2-1/2, 3, 3-1/2 and 4 inch) (Fig 6).
2. Secure with 5/8” bolt to hold in place (Fig 7).
UNDERGROUND PULLS
1. Assemble puller and attach correct size conduit adaptor.
2. Pivot Front Extension assembly to desired angle and
reinsert pin (Fig 8).
3. Lift front end and place conduit adapter into conduit.
Always make sure the conduit adaptor sits flush around the
conduit you are pulling through (Fig 9).
4. Replace pin front assembly to lock all parts tight. (This must
be pinned for the puller to operate properly and safely).
5.
WARNING: Do not stand in line with the rope being pulled
(stand to the side of the drill) to avoid injury if rope breaks.
6. Use Southwire NoLUBE
®
SIMpull
®
cables or add proper
lubricant for all your pulling jobs.
7. Loosely wrap rope around the capstan in a clockwise
direction from the inside out. Start the electric drill by
rotating the Maxis
®
3K’s switch lever. Pull on the rope to
produce some tension. The rope will begin to advance.
Fig 6
Fig 7
Fig 5
Fig 4
Fig 1
Fig 2
Fig 3
