10
9
ATTACHING THE TOOL BAG
SET UP AND OPERATION
SET UP AND OPERATION
1. Separate the top three strips of hook and loop from each
other.
2. Rewrap them tightly around the top bar main frame behind
the handle of the cart (Fig 1).
3. Separate both side strips of hook and loop from each other.
4. Rewrap each side tightly around the side mainframe of the
Cart (Fig 2).
ATTACHING THE PULLER
1. Once the wheel assembly has been completed, be sure that
your Maxis
®
3K or 6K is disassembled into two parts (Fig 1).
2. Insert the gearbox portion if the puller into the sleeve
mounted in the middle of the carts carrying plate with the
base plate up (Fig 2).
3. Push the pullers base plate back so the carts anchor shaft
protrudes from the pullers base plate.
4. Install cotter pin through anchor shaft to lock the puller
gearbox section in place (Fig 3). Note: Puller cart anchor
shaft will be positioned on the top right of the support bar
for the Maxis
®
3K and on the right of the main frame for the
Maxis
®
6K (Fig 3a).
5. Take the pullers front arm extension and slide the sleeve
onto the post on the left side of the carts carry plate (Fig 4).
6. Using the pullers hitch pin, slide pin through one of the
pullers adjustment holes and the mounting hole located on
the left side of the cart (Fig 5-6). Note: Puller cart extension
hole for the Maxis
®
3K is located approximately 9 inches
from the top and 6 inches from the top on the Maxis
®
6K
(Fig 7).
Fig 1
Fig 2
7. Lock the pullers front arm extension into place by inserting
the cotter pin into the hitch pin (Fig 8).
Fig 1
Fig 2
Fig 3
Fig 3a
Fig 4
Fig 5
Fig 6
Fig 8
Fig 7
