South Bend Tools
For Machines Mfd. Since 10/21
Model SB1118
-21-
P R E P A R A T I O N
Figure
Figure 19. Leveling extension table.
. Leveling extension table.
3.
Using a straightedge as a guide (see Figure
19), rotate set screws installed in Step 2
until extension tables are level and flush
with planer table.
Minimum CFM at Dust Port: 600 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine
the CFM at the dust port, you must consider
these variables: (1) CFM rating of the dust
collector, (2) hose type and length between the
dust collector and the machine, (3) number of
branches or wyes, and (4) amount of other open
lines throughout the system. Explaining how to
calculate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
Dust Collection
This machine creates a lot of wood chips/
dust during operation. Breathing airborne dust
on a regular basis can result in permanent
respiratory illness. Reduce your risk by
wearing a respirator and capturing the dust
with a dust-collection system.
To connect machine to a dust collector:
1.
Fit a 6" dust hose over dust port (see Figure
21), and secure in place with a hose clamp.
2.
Tug hose to make sure it does not come off.
Note:
A tight fit is necessary and ensures
proper performance during operation.
Figure
Figure 21. Dust hose attached to dust port.
. Dust hose attached to dust port.
Figure
Figure 20. Bed roller height handle installed in hub.
. Bed roller height handle installed in hub.
Handle
Handle
Hub
Hub
4.
Install bed roller height handle (see Figure
20) in hub on right side of front extension
table.
