South Bend Tools
For Machines Mfd. Since 10/20
Model SB1100 & SB1101
-39-
M A I N T E N A N C E
9.
Loosen hex bolt and remove lower alignment
arm from filter brush spindle (see Figure
73), then attach lower alignment arm to new
canister filter.
12.
Inspect foam tape on upper rim of collector
and replace if worn or dirty. Trim excess
tape so ends meet evenly without overhang
or gap (see Figure 75).
Figure 75. Tape applied to top rim of collector.
Figure 76. Canister filter secured to collector with
canister clamp.
13.
Position canister clamp around base of
canister filter, then place canister filter over
collector (see Figure 76). Tighten clamp.
Canister
Clamp
Canister
Filter
Collector
10.
Position filter cover assembly over new
canister filter. Rotate lower alignment arm
so "V" on upper alignment arm captures
lower arm when mounting holes align (see
Figures 73–74).
Figure 74. Underneath filter cover assembly.
Upper
Alignment
Arm
11.
Attach filter cover assembly to canister filter
with flange bolts removed in Step 8.
Figure 73. Top of canister and lower alignment arm.
Lower
Alignment Arm
Mounting
Holes
