Chapter 5 Function parameter
53
5-2-3.F1 Gruop - Input terminals group
Code
Parameter name
Setting range
Factory
default Change
F1.00 DI1 terminal function
selection
0: No function
1: Forward run (FWD)
2: Reverse run (REV)
3: Three-wire operation
control
4: Forward Jog
5: Reverse Jog
6: Frequency setting
increment (UP)
7: Frequency setting
decrement (DOWN)
8: Free stop
9: Fault reset
10: External fault input
11: Frequency change
settings clear
12: Multi-speed terminal 1
13: Multi-speed terminal 2
14: Multi-speed terminal 3
15: Multi-speed terminal 4
16: Ac/deceleration time
selection
17: Control command switch
terminal
18: Ac/deceleration
prohibited
19: STD control pause
20: Wobbulate pause (stops
at the current frequency)
21: Wobbulate reset (returns
to the center frequency)
22: Torque control prohibited
23: Frequency change
settings temporarily clear
24: Stop DC braking
25: Reserved
1
★
F1.01 DI2 terminal function
selection
2
★
F1.02 DI3 terminal function
selection
8
★
F1.03 DI4 terminal function
selection
9
★
F1.04 DI5 terminal function
selection
4
★
F1.05 Reserved
This parameter is used to set functions of digital multi-function input terminals.
0: No function
1: Forward run (FWD)
2: Reverse run (REV)
External terminals are used to control the FWD/REV run mode of inverter.
3: Three-wire operation control: this terminal is used to determine the three-wire
operation control mode of the inverter;For details, see the introduction of F1.06 three-
wire function code.
