9
ENGLISH
ZEUS II series User manual
6)^MODE SWITCH
Allows the selection of STEREO (Dual) or BRIDGE operation modes.
7)^LIMITER SWITCH
This switch is used to activate (ON) or disable (OFF) the protection of the input com-
pression circuit. This protection function is used to decrease the possibility that one or
both channels are clipping or overloaded.
8)^Bridged OUTPUT
When the device is set to BRIDGE mode, the input signal of channel A will be present
on the Output Speakon® named BRIDGE.
6. REAR PANEL
- H-1800, H-2700
INPUTS
CH-B
CH-A
1.4V
0.775V
SENS.
BRIDGE
PARALLEL
STEREO
MODE
RESET
230V - 50/60Hz
WARNING! ONLY USE THE
POWER CABLE SUPPLIED
WITH THIS PRODUCT
MADE IN P.R.C.
S/N:
ZEUS SERIES
POWER AMPLIFIERS
BRIDGE
DUAL
DUAL
CH-B
CH-A
OUTPUTS
1
2
3
4 5
6
7
1)^AC POWER CONNECTOR
Plug the power cord into an AC socket properly configured for your particular model.
Note: If you happen to lose the AC line-cord, always use a three-pin plug
with a ground pin. The wire correspondence is as follow:
Cable
Pin
International
Brown
Live
L
Blue
Neutral
N
Yellow/Green
Earth
Always connect the earth! Pay attention to your safety!
Before taking into operation for the first time, the installation has to be approved by an
expert.
2)^OUTPUT CONNECTORS
Each channel has one Speakon® and one binding post outputs for connecting to the
loudspeakers.
