transmission power in order to cancel these problems.
8.5. IR Sync Function
The WF-D190 MKII comes with an infrared transmission system between receiver and
transmitter that easily sends all settings to your hand-held or pocket transmitter. To
activate the IR function:
f
Turn on the receiver and hold for a few seconds UNLOCK key to unlock it. LOCK
icon will turn off. Now you can choose between manual channel setting or auto scan
procedure to find the best frequency to be used.
Manual Channel Setting
f
Once you have located an interference-free channel (please refer to “11. FREQUEN-
CY TABLE” at page 21), rotate SETUP knob, and press it to enter into channel set-
ting mode while GR/CH is highlighted.
f
Rotate control knob again to select the appropriate menu item (GR or CH) and press
the knob to confirm.
f
Select the appropriate group and channel by increasing or decreasing and, after
finished, press the control knob to confirm.
f
Finally press for about 2 seconds IR button to sync the receiver to the handheld
transmitter or bodypack.
icon will flash for about 15 seconds, indicating that the
receiver unit is sending the information through the IR sensor.
f
Bring the handheld or pocket transmitter as close as possible to the receiver’s IR
sensor.
setup
vol
setup
vol
f
Once the transmitter is synchronized,
icon stops blinking; MUTE icon turns off,
battery
and transmission power
HI
or
LO
icons light up, indicating that the sys-
tem is now working properly.
17
ENGLISH
WF-D190 MKII User manual
