1.
IMPORTANT: Make sure that ALL stereo system components including the THP-CXB are turned OFF before proceeding.
2. Locate the line output RCA connectors on the back of the preamplifier. These may be marked by the manufacturer as:
PRE, PRE OUT, LINE OUT, MAIN OUTPUTS TO POWER AMP
3. Connect a pair of high-quality line-level connection cables RCA patch cords between the pre amps MAIN OUT con-
nections and the LINE IN connections on the back of the THP-CXB. Make sure that left is connected to left and right is
connected to right. We recommend that you treat the RED connection cable RCA plug as RIGHT and the BLACK or GREY
plug as LEFT.
4.
Connect another set of connection cables between the THP-CXB LINE OUT connections and the INPUTS of the power
amplifier. Again, make sure that left is connected to left and right is connected to right.
5.
Connect with cables the main speakers to the speaker terminals on the back of the power amplifier.
6.
Connect with cables the Soundolier or other subwoofer to the round red and black “TO SUBWOOFER” terminals on the back
of the THP-CXB. Make sure that polarity is correct, using the BLACK binding post for the connection and the RED
binding post for the ( + connection.
7. IMPORTANT: Consult the owner’s
manual that came with the
subwoofer to determine if it is rated
at 4 ohms or 8 ohms. Then set the
OHM 8 O H M ”
switch accordingly. If you are using
two subwoofers, refer to the section
titled; “Using Two
on
page
4.
NOTE: See Section C: THP-CXB
REAR PANEL TOUR, OHM/
8 OHM switch”, for additional infor-
mation on page 3.
8. You
are now ready to put the
and subwoofer to use. Skip to
the next section, titled: THP-CXB
Front Pane/ Mini Tour on page 10.
Line Level Hook-Up
with Preamplifier and
Power Amplifier
