4
INSTALLATION
IMPORTANT
The HONPDSDR module can emulate one of three audio sources at a time: CD, XM1/
XM2 or XM2. Use XM1/XM2 emulation in vehicles without a factory satellite radio. Use
XM2 emulation in vehicles with a factory satellite radio; your factory satellite tuner will be
retained as XM1. For Acura vehicles please see note 3 on the front page. Use CD emulation
mode if your vehicle is not satellite capable. Use of your factory CD changer is retained.
CD Mode does not support text display. Set your emulation mode according to the switch
settings below. If you are installing the HONPDSDR in the Honda Gold Wing you must use
CD emulation mode. Please see page 10 for Gold Wing installation instructions.
BEFORE YOU BEGIN:
1. Turn the ignition off.
2. Remove the negative battery terminal.
3. Have your radio security code, if equipped.
Installation
2
DIP ON
2
DIP ON
2
DIP ON
2
DIP ON
XM1/XM2 Emulation
XM2 Emulation
CD Emulation
Gain access to the factory radio’s rear panel.
The
HONPDSDR connects directly to the rear panel of the factory radio. Full
or partial disassembly of the dash will be necessary. If you are unsure of
this procedure, please consult a factory service manual or have the work performed by a mobile
electronics specialist. Pay special attention to warnings or instructions regarding working near
airbags, other safety devices, or security systems.
1
1
Connect the appropriate harness to the factory radio.
If there is a factory 14-pin plug present, disconnect it and replace it with
the 14-pin male plug on the HONPDSDR Harness. Take the remaining
14-pin female connection of the HONPDSDR Harness and plug it into the disconnected factory
plug.
2
2
3
3
To Use XM2 Emulation:
With the main connection of the HONPDSDR
Harness in place, you will need to install the HONSAT Harness in one of
two confi gurations based upon your vehicle and its options.
OR
