V1.22
Owners Manual SP20-Linex™
- 26 -
6.4
General set-up of a flown array
Step 0: (optional) Connect single-hoist adapter to fly-frame
The single-hoist-adapter allows flying of a maximum of 12 cabinets to a single motor-hoist.
SPArC™ indicates the proper fixing hole to lift the array, resulting in the appropriate angle of the
completed array.
Step 1: Connect motor hoist to fly-frame
The
S
asy-rig™ fly-frame comes with a lifting and, when using the tilt-bar, a tilting point.
SPArC™ provides information on the loads on each of these points. Connect the motor hoist(s)
to the lifting point. After lifting the first array out of the flightcase an optional motor hoist can be
fixed to the tilting point. During the rigging procedure only use the lifting point at the front of the
frame to hoist the array out of the flight-case. Once the full array is at the intended height it can
be tilted to the right angle at the tilting point.
IMPORTANT: Make sure the shackles
on the fly-frame are securely closed
before any use of hoist motors!
Note: In case SPArC™ indicates the
lifting point carries the full load, a
single hoist can lift the array. A simple
strap can be used to aim the array
horizontally and keep the array from
rotating.
