USE AND MAINTENANCE MANUAL
MANUAL DOUGH SHEETER
Mod. SPT0/1-E - SPT3/1-E
Code
3529.0031.01
Revision A
date 06/09/2011
18
Technical Assistance Service - Phone (+39) 0445.595.111
Arc. 86
3.2 CONNECTION TO THE MAINS
−
The machine is provided with one single electrical connection with connection cable at the rear.
−
Check that the rating plate voltage corresponds to the mains voltage.
−
The machine must be connected to a manual control voltage disconnection device fitted in an
easily accessible position so that the machine electrical equipment can be separated from the
mains when necessary (e.g. during maintenance or cleaning).
−
For sizing of the cable and disconnection device, see wiring diagram data.
−
If not supplied, fit a retention plug to the machine connection cable suitable for the
disconnecting device installed and connect to the socket.
−
Following the operating instructions (Chap. 4), with the machine empty, start and run a few right
and left rolling tests, adjusting the rolling thickness.
−
To connect the plug to the supply cable (when not provided) refer to figure –a1-; this operation
must be performed in compliance with the “CAUTION” note at the foot of the page.
Fig. –a1-
NOTE: REGULATIONS FOR SAFETY OF ELECTRICAL SYSTEMS
In Italy electrical equipment must meet the requirements not only of the CEI technical
specifications but also the provisions of the law of 5.3.1990, no. 46, and related Implementation
Regulation, DPR 6.12.1991, no. 47.
In particular, the system must be installed by a technically and professionally qualified electrician
listed in the appropriate register. The installer is obliged to provide the customer with a declaration
of conformity.
Old systems should be checked in order to adapt them to the latest safety regulations and state-
of-the-art.
!
CAUTION
Operations on the electrical part of the machine, even if minor, must be
performed by professionally qualified personnel.
