© 2003-2022 SOTA Instruments Inc.
Page 6 of 11
|
www.sota.com
The SP Lite Model SPL1 Manual
11.
When finished, turn the unit OFF by rotating the ON/OFF switch counter clockwise
until it clicks. do not force the on/off switch past its natural stopping point.
12. Unplug the micropulsing cord. do not store the unit with the micropulsing cord
plugged in as this can damage the cord.
13. clean the wrist and apply a healing lotion to avoid irritation.
Notes:
Suggestions for Feeling the Current:
if the current is not felt with wet cotton
Sleeves, prepare a mild salt solution to wet the sleeves. Add a few grains of salt to
the water in a dropper bottle.
drink enough water to keep the body well
hydrated. hydration can affect the ability to
feel the current.
Care of Micropulsing Cord:
discoloration
of electrodes is normal. Buff occasionally
to remove stains to ensure good electrical
contact.
Care of Cotton Sleeves:
Wash or rinse sleeves
occasionally. periodically discard and replace
cotton Sleeves.
Alternatives to Cotton Sleeves:
a. Sponge Sleeves: available from SotA.
b. cotton Sleeves with velcro
®
used with a velcro
®
Wrist Strap: available from SotA.
c. Unbleached paper towel: cut a small square of paper towel large enough to wrap
around the probe 2 or 3 times.
d.
Cotton Flannel: Cut a small square of cotton flannel and wrap around the probe.
Secure it in place with thread.
Power Supply:
When micropulsing, as a safety feature, the unit can only be powered
by a 9-volt Alkaline battery.
Replacement Batteries:
When purchasing replacement 9-volt batteries, take the
Silver Pulser with you to ensure a proper fit, as 9-Volt batteries vary in size. Alkaline
or rechargeable batteries are recommended.
