The Bio Tuner Model BT8 Manual
© 2012-2018 SOTA Instruments Inc.
Page 6 of 9
|
www.sota.com
Care of Bio Tuner Cord and Ear Clips:
Occasionally, remove the conductive rubber from
the Ear Clips to clean in a mild soap solution.
Rinse thoroughly. If necessary, gently wipe the
metal pins of the Bio Tuner Cord.
Low Battery Warning:
The RED light comes on
when the battery is low. This means the battery
will soon need to be replaced.
Replacement Batteries:
When purchasing
replacement 9-Volt batteries, take the Bio Tuner
with you to ensure a proper fit, as 9-Volt batteries
vary in size.
HOW IT SHOULD FEEL
1. The sensation is a pleasant buzzing. It is not necessary to turn the control up to an
uncomfortable level. If it feels prickly or unpleasant, check the following:
a. Wet the conductive rubber of the Ear Clips again.
b. Apply conductive gel or aloe vera gel to the ear lobes.
c. Clean the Conductive Rubber Electrodes.
d. Replace the Conductive Rubber Electrodes.
2. With repeated use, the buzzing sensation may not be felt as much. The intensity
may be turned up if desired.
3. You may feel a sensation on one side more than the other.
4. In rare instances, some individuals may not feel the current.
TYPICAL USE
Length of session:
One cycle is timed for approximately 20-minutes. One session can
be 20 to 40 minutes (1 to 2 cycles).
Information indicates that if used longer than 40 minutes per session, the benefits
may be reduced. The unit can be used for up to three 40-minute sessions per day—
space the sessions throughout the day.
Length of use:
The unit should be used daily, at least 2 sessions per day, for a
minimum of 4 weeks or longer. After the benefits have been achieved, simply use the
unit as needed.