The Bio Tuner Model BT8 Manual
© 2012-2018 SOTA Instruments Inc.
Page 4 of 9
|
www.sota.com
HOW TO USE THE BIO TUNER
1. Place the 9-Volt Alkaline battery in the unit.
a. On the back of the unit, slide off the
battery cover.
b. Position the 9-Volt Alkaline battery so the positive
(+) and negative (-) terminals line up as in image 1.
Note: The smaller circle on the battery matches the
smaller circle in the case … the larger battery circle
matches the larger circle in the case.
c. Slide the 9-Volt Alkaline battery into the case and push down.
d. Slide the cover back onto the unit.
2. Clean the ear lobes to eliminate skin oils. This will allow for better conductivity.
3. Slide the clip on the back of the Bio Tuner into the
holding clip on the Arm Band as in image 2.
4. Insert the cord into the jack on the unit as shown in
image 3. The USB symbol on the plug should be
facing up as shown. When the plug is positioned
correctly, it will slide in gently. Do not force.
5. Slide the Arm Band, with the unit and cord, up
the arm to a comfortable
position. Tighten the band to
secure it in place as in image 4 on page 5.
Option: If preferred, the unit can be placed in a pocket.
6. Insert the pins on the cord into the Ear Clips.
7. Wet the conductive rubber on the Ear Clips with water or
conductive gel.
8. Place one Ear Clip on each ear lobe, positioning the Ear
Clip with the conductive rubber at the back of the ear lobe
and close to the jaw as in image 5.
9. Turn the unit ON by turning the ON/OFF switch
clockwise.
3
1
2