service record
23
2.5.2 Leg supports: standard or angle adjus-
table
Setting distance between footrest and seat board
The distance between top edge of the seat board and the
top edge of the footrest can be adjusted in the same way by
standard leg supports (1)
continuous or divided and
angle
adjustable leg supports (2)
continuous or divided:
• (3)
Remove both screws
(A)
,
• remove the footrest/s and
• move the footrest/s along the holes
(B)
in the
new position/s.
• Replace both screws
(A)
and tighten them.
INFORMATION
When it comes to a continuous footrest you must move
both connections of the footrest parallel on the leg sup-
port.
Setting the stop angle of the footrest/s
(4)
With both adjusting screws you can adjust the stop angle
of the footrest/s.
• Flip the footrest/s back,
• loosen the lock nut
(A)
• turn both adjusting screws
(B)
until you have
reached the wanted angle,
• retighten the lock nut
(A)
.
ATTENTION
Both adjusting screws must fit close to the tubes (C)
when the footrest/s is/are in use. Avoid an uneven fitting
position of the adjusting screws.
(3)
Distance t
op edge
seat boar
d to t
op
edge f
oot rest
(2)
(1)
Distance t
op edge
seat boar
d to t
op
edge f
oot rest
(A)
(B)
(A)
(B)
(C)
(4)
