Instructions for use Airon
Instructions for use Airon
11 of 36
2021-06-10
2 General information
(2)
(1)
90°
(B)
(A)
(3)
(4)
(D)
(C)
(2)
(1)
When using the wheelchair as a seat in the motor vehicle, only use the places
marked with the symbol for the attachment point. These are usually located in the
back left and right
(1)
and front left and right.
(2)
Attachment points / methods for transportation in motor vehicles
The wheelchair must be attached using a
vehicle-anchored 4-point wheelchair restraint
system in accordance with ISO 10542. These
can be snap hooks, S-shaped hooks or snap
fasteners. The wheelchair restraint system
must be securely attached and used in ac-
cordance with the manufacturer's instructions
for use.
(3A+B)
In order to reduce the risk of head and
upper body injuries as much as possible,
the user must also be secured with a fixed
lap belt
(4C)
approved for transport in ac-
cordance with ISO 10542 and a vehicle-an-
chored shoulder belt
(4D).
If the wheelchair is equipped with a back angle adjustment or seat tilt, it must be ensured
that the occupant sits in an upright position with a back angle of 90 ° during transport
(3)
.
Legrests that can be swiveled up must be set to the lowest position.
The seat belts must not be twisted during use or passed over components and thus kept
away from the body. They have to be tight and tight without compromising user comfort. The
lap belt buckle must be between the pelvic bones (as centrally as possible). The buckle tongues
on the lap belt for fastening the shoulder belt should be on the outside of the pelvis, if possible.
All belts used for transport must be checked for damage at regular intervals.
A headrest approved for transport must be used.
According to ISO 7176-19, the wheelchair may only be used as a forward-facing seat in
motor vehicles. No transport with side orientation!
After a collision, immediately contact your specialist retailer to check the chassis, frame
and brakes and have any damage repaired by a professional.
