28
Settings
menu 5
10
10
10.13 Party Function
With the party function the storage temperature is heated up once to the
reference temperature (TrefS3, respectively TminS3 in energy saving mode).
The party mode is enabled by pressing the „esc“-key for 3 seconds in the
main menu. While this mode is active, the system heats up to the reference
value + hysteresis, unattached to preset thermostat times. The mode is
ended once the required temperature is reached.
A setting must be made as to which storage tank (storage tank sensor)
has priority for charging. Charging of the lower-priority storage tank is in-
terrupted at regular intervals to check whether the temperature increase
at the collector can enable charging of the higher-priority storage tank.
Setting range: S2 or S3/default setting: S2
In systems with two storage tanks charging of the lower-priority storage
tank will never take place until this set temperature setpoint at the storage
tank sensor of the higher-priority storage tank is exceeded.
Setting range: from 0°C to 90°C/default setting: 40°
10.14 Priority sensor
menu 5.x
= charging priority in systems with two
storage
tanks
10.16 Charging pause
menu 5.x
= interruption of charging
The charging of the lower-priority storage tank is interrupted after the sett-
able time in order to check whether the collector can reach a temperature
level that will soon enable charging in the higher-priority storage tank. If
the conditions for charging the higher-priority storage tank or for continued
interruption are not met, then the charging of the lower-priority storage tank
is enabled again and interrupted again after the time set here in order to
consider the current temperature increase of the collector.
Settings range: 5 to 90 minutes / Default: 10 minutes
10.15 T priority
menu 5.x
= temperature threshold for absolute priority
