19
Parametrisation
5
5
The
fi
rst time the controller is turned
on and after the language and time
are set, a query appears as to whether
you want to parametrise the controller
using the commissioning help or not.
The commissioning help can also be
terminated or called up again at any
time in the special functions menu.
The commissioning help guides you
through the necessary basic settings
5.1 Commissioning help
Caution
Observe the explanations for the the individual parameters on the
following pages, and check whether further settings are necessary for
your application.
5.2 Free commissioning
If you decide not to use the commissioning help, you should make the neces-
sary settings in the following sequence:
- Menu 10. Language (see 14.)
- Menu 7.2 Time and date (see 12.2)
- Menu 7.1 Program selection (see 12.1)
- Menu 5. Settings, all values (see 10.)
- Menu 6. Protective functions if adaptations are necessary (see 11.)
- Menu 7. Special functions if additional changes are necessary (see 12.)
Finally, menu 4.2 under operating mode “Manual“ should be used to test the
switch outputs with the consumers connected, and to check the sensor values
for plausibility. Then switch on automatic mode.
in the correct order, and provides brief descriptions of each parameter in the
display. Pressing the “esc” key takes you back to the previous value so you can
look at the selected setting again or adjust it if desired. Pressing the “esc“ more
than once takes you back step by step to the selection mode, thus cancelling the
commissioning help. Finally, menu 4.2 under operating mode “Manual” should
be used to test the switch outputs with the consumers connected, and to check
the sensor values for plausibility. Then switch on automatic mode.
Caution
Observe the explanations for the the individual parameters on the
following pages, and check whether further settings are necessary for
your application.
