Sony XDCAM XDBK-J102, Installation Manual

Page: 21 / 28

1-13 (E)
XDJ-1000
Attaching the outer rail
9. Temporarily secure the rail bracket at four portions
(front, rear, right and left) with the eight screws and
four plate nuts (small) to the position (space by 5U) of
the rack on which this unit is mounted as shown in the
illustration.
10. Securely tighten the eight screws to fi x the rail mount-
ing bracket at four portions which were temporarily
secured to the right and left outer rails in steps 7 and 8.
Tightening torque:
138
x
10
_
2
N
.
m {14 kgf
.
cm}
PSW
4
x
12
31.75 mm
PSW
4
x
12
Rail bracket
Plate nut (small)
Space
by 5U
PSW4
x
12
Rack angle Plate nut
(small)
Outer rail
Rack
A
A’
Distance: A = A’ = 426 mm
Intermediate rails
Ball retainer
Intermediate rail
11. Check that the intermediate rails attached to both sides
are parallel to each other.
12. Securely tighten the eight screws to fi x the right and
left rails which were temporarily secured to the rack in
step 9.
Mounting in rack
c
Be sure to carry the unit by the two persons or more.
13. Slide each ball retainer of intermediate rails on both
sides (left and right) in the direction of the arrow.