Sony XDCAM XDBK-J102, Installation Manual

Page: 13 / 28

1-5 (E)
XDJ-1000
4. Fix the drive mounting plate to the drive assembly with
the four screws supplied with XDBK-J102.
5. Align the edge portions of the drive mounting plate
with the board supports and move it in the direction of
the arrow to the position where the power cable and
the SATA cable can be connected respectively.
6. Connect the power cable and the SATA cable, then fi x
them with the clamp.
7. Push the drive mounting plate as far as it will go while
being careful not to pinch the cables.
8. Fix it with the four screws.
1-6. Installation of XDBK-J102
1. Remove the four screws, then pull out the drive mount-
ing plate.
2. Remove the two harnesses from the two clamps, then
remove the drive mounting plate.
3. Remove the two screws, then remove the blank panel.
B3
x
5
Drive mounting plate
PSW3
x
6
Drive mounting plate
Harnesses
Clamps
Blank panel
Drive mounting plate
PSW3
x
6
(supplied with XDBK-J102)
Drive assembly
Edge portion of
drive mounting plate
Board supports
Power cable
SATA cable
Clamp
B3
x
5