96
Troubleshooting
A
ppen
dix
Alarms relating to audio and video signals
Alarms relating to sensors and drivers
Delete is Prohibited.
This Clip is in Use.
The target clip is being used, so it cannot be deleted.
Delete is Prohibited.
Referring EDL is in Use.
The EDL which refers to the target clip is being used, so the clip cannot be deleted.
Delete is Prohibited.
Deletion of the target clip has failed.
Lock/Unlock is Prohibited.
This Clip is in Use.
The target clip is being used, so it cannot be locked/unlocked.
Lock/Unlock is Prohibited.
Lock/unlock of the target clip has failed.
Set Clip Flag was not
Performed.
Set Clip Flag function has failed.
One Clip is being
Recorded.
Use Single Selection.
One of the selected clips was being recorded.
To copy a clip which is being recorded, make a single selection of the clip.
Operation is not
Supported for EDL.
You cannot select EDL to delete an essence mark or set a shot mark.
Adding EM was not
Performed.
Essence mark setting has failed.
Over DUR!
A clip with a duration that exceeds six hours cannot be copied.
Cannot Display Chapter of
this Clip.
The selected clip has failed in chapter thumbnail display.
Stop recording of a clip if any in progress.
Chapter was Changed.
Display Again.
The chapter setting information has been updated.
Try again the chapter thumbnail display.
Chapter does not Exist.
Chapter thumbnail screen cannot be displayed because no chapters are set on the clip.
Cannot Expand this Clip.
The clip cannot be expanded because it is being recorded.
Unable to Parse the EDL.
The EDL cannot be copied due to existence of an inhibiting condition such that there is no sub clip.
Out of Remain Space!
The remaining capacity of the copy destination media is not sufficient.
Alarm message in status
display area
Alarm message in video monitor screen Description/action
No INPUT!
INPUT VIDEO IS NOT DETECTED.
CHECK THE VIDEO INPUT MODE AND
SUPPLY A VIDEO SIGNAL TO VIDEO
INPUT.
• Check the setting of V INPUT on page P1 INPUT of
the function menu
• Input an HDSDI signal.
EMPHASIS!
INPUT AUDIO EMPHASIS IS NOT
SUPPORTED.
CHECK THE EMPHASIS OF THE AUDIO
INPUT SIGNAL.
Check the emphasis of the audio input signal.
REF Not Exist
–
Input a reference signal.
REF NON-STD
A NON-STANDARD REF SIGNAL IS
BEING USED FOR REF VIDEO.
USE A STANDARD SIGNAL.
Input a standard reference signal.
Alarm message in status
display area
Alarm message in video monitor screen Description/action
MEM-138 Warning
IT IS NESSESARY TO REPLACE MEM-
138.PLEASE CONTACT SERVICE.
Contact your Sony representative.
Note
The unit will not stop operating, but if you continue to
use it in this state, it may get broken sooner or later,
resulting in a total loss of the information.
Alarm message in clip
list screen
Description/action
