Sony WX-GT90BT, Operating Instructions Manual

Page: 34 / 260

34
*1 When the unit is turned off.
*2 Does not appear in App Remote.
*3 When FM is received.
*4 When the tuner is selected.
*5 When the CD or USB is selected.
SOUND:
AUX-A *
1
*
2
(AUX Audio)
Activates the AUX source display: “ON,”
“OFF” (page 36).
CT (Clock Time)
Activates the CT function: “ON,” “OFF”
(page 13).
REGIONAL *
3
Restricts reception to a specific region:
“ON,” “OFF” (page 12).
BTM *
4
(page 11)
ZAPPIN *
5
ZAP TIME (Zappin Time)
Selects the playback time for the
ZAPPIN function.
– “Z.TIME-1 (about 6 seconds),”
“Z.TIME-2 (about 15 seconds),”
“Z.TIME-3 (about 30 seconds).”
ZAP BEEP (Zappin Beep)
Applies a beep sound between track
passages: “ON,” “OFF.”
EQ7 PRESET (page 31)
EQ7 SETTING (page 31)
POSITION
SET F/R POS
(Set Front/Rear Position)
(page 32)
ADJ POSITION
*
1
(Adjust Position)
(page 32)
SET SW POS * 1 (Set Subwoofer Position)
(page 32)
BALANCE
Adjusts the sound balance: “RIGHT-15”
– “CENTER” – “LEFT-15.”
FADER
Adjusts the relative level: “FRONT-15” –
“CENTER” – “REAR-15.”
DM+ * 2 (page 32)
LOUDNESS (Dynamic Loudness)
Reinforces bass and treble for clear
sound at low volume levels: “ON,”
“OFF.”
ALO (Automatic Level Optimizer)
Adjust the playback volume level of all
playback sources to the optimum level:
“ON,” “OFF.”
RB ENH * 3 (Rear Bass Enhancer)
RBE MODE (Rear Bass Enhancer
Mode)
Selects the rear bass enhancer mode: “1,”
“2,” “3,” “OFF.”
LPF FREQ (Low Pass Filter Frequency)
Selects the subwoofer cut-off frequency:
“50Hz,” “60Hz,” “80Hz,” “100Hz,”
“120Hz.”
LPF SLOP (Low Pass Filter Slope)
Selects the LPF slope: “1,” “2,” “3.”
SW DIREC *
4
(Subwoofer Direct
Connection)
SW MODE (Subwoofer Mode)
Selects the subwoofer mode: “1,” “2,” “3,”
“OFF.”
SW PHASE (Subwoofer Phase)
Selects the subwoofer phase: “NORM,”
“REV.”
SW POS * 1 (Subwoofer Position)
(page 32)
Selects the subwoofer position: “NEAR,”
“NORMAL,” “FAR.”
LPF FREQ
(Low Pass Filter Frequency)
Selects the subwoofer cut-off frequency:
“50Hz,” “60Hz,” “80Hz,” “100Hz,”
“120Hz.”
LPF SLOP
(Low Pass Filter Slope)
Selects the LPF slope: “1,” “2,” “3.”