NW-ZX505/ZX507
39
Sony CONFIDENTIAL
For Authorized Servicer
2-16. MAIN BOARD-2
Note 1:
When the MAIN board is replaced, make sure to refer to
“IMPORTANT NOTE OF REPLACING THE MAIN
BOARD” on page 7.
2
two step screws
front side
top side
bottom side
1
support
(rear
bottom)
4
screw M1.4
(L = 3.0 mm)
3
USB holder block
4
screw M1.4
(L = 3.0 mm)
4
screw M1.4
(L = 3.0 mm)
hole
boss
hole
hole
0
MAIN board
(See Note 1)
8
Remove the MAIN board
in the direction of the arrow.
6
Move the LCD FPC
to the outer side.
7
Move the BTL HP detect connector
wire to the outer side.
9
Draw the card
connector
out
of the hole.
9
Draw the USB
connector
out
of the hole.
5
Lift up the MAIN board in
the direction of the arrow.
Note
2:
When installing the MAIN board,
align the hole and boss.
board positioning boss
(See Fig. E)
board positioning boss
board positioning hole
(See Fig. E)
< Fig. E >
board positioning hole
– MAIN board conductor side –
top side
USB connector
top side
Note about installing the MAIN board
When installing the MAIN board, make sure to align the board positioning hole and board positioning boss.
If the board positioning hole and board positioning boss are not aligned, the USB connector will be raised.
Check that the USB connector is not raised and that the board positioning hole and board positioning boss
are aligned before installing.
SYS SET
2019/12/13 00:24:41 (GMT+09:00)
