Sony VID-P110, Service Manual

Page: 12 / 82

1-6 (E)
VID-P110
10
Preparation
Camera stand
UNLOCK lever
3
Open both arm lights until they fix in place.
4
Connect the power cord to the AC IN connector on
the rear panel.
Arm light Arm light
Precautions
• Unplug the VID-P110 from the wall outlet when it is
not being used for a long period of time. To
disconnect the cord, pull it out by grasping the plug.
Never pull it out by the cord itself.
• The fluorescent lamps can get hot during operation.
Do not touch the lamps during operation and when
collapsing the VID-P110.
• Clean the cabinet with a soft cloth lightly moistened
with a mild detergent solution. Never use any type of
solvent such as alcohol or benzine, which might
damage the finish.
• Clean the lens with an air spray or soft dry cloth,
taking care not to scratch it.
• When the fluorescent lamps flash or get darkened, the
fluorescent lamps should be replaced with new ones.
In this case, contact your Sony dealer.
Setting Up the Unit
1
Lift up the camera stand while keeping the
UNLOCK lever pressed down.
2
Adjust the camera to the direction shown by the
arrow so that the lens faces downwards.
11
Connecting the Unit to Other Equipment
Notes on connections
• Before making any connections, turn off the power of
the VID-P110 and the equipment to be connected.
Example of connections to this unit
a) Note
It is recommended that you use the DIN 4-pin cable
when you connect this unit to the equipment with an S
video input or output connector.
• For NTSC model only: Before connecting a device
such as a monitor to the VID-P110 AC OUT
receptacle, check to see if the power consumption is
2.5 A or less. Do not connect any device whose
power consumption is over 2.5 A to the VID-P110.
Microphone
MIC
VID-P110 (Front)
AC inlet
AC outlet
AC power cord (supplied)
AC IN
AC OUT (NTSC
model only)
VIDEO OUT 1
(phono jack)
Video cable
Video input
connector
Color monitor
VID-P110
(Rear panel)
S VIDEO IN 1 or 2 AUDIO L, R
1 or 2
S VIDEO OUT
S video input
connector
DIN 4-pin cable a)
VIDEO IN
1 or 2
VIDEO OUT 2
(BNC type)
Video input connector
Video cable
AUDIO L and
R OUT
Audio cable
Audio
input connectors
DIN 4-pin cable a)
or
Video
cable
Audio cable
S video
output
connector
Video
output
connector
Audio output
connectors
AC power cord (not supplied)
Front
Rear
or
Video equipment
Projector
Screen
Speaker
Amplifier