Sony UP-D2600, Service Manual

Page: 29 / 132

1-23
UP-D2600/V1(E)
14
Preparation
Notes
• SCSI cable connection requirement can vary between different computers and
peripherals. For the details of your installation, refer to the manual of your
computer and peripherals.
• Be sure not to connect the external terminator to the SCSI connector when the
terminator switch of the DIP switches is set to ON.
Turning on the power
You should turn on all peripheral devices before turning on your computers.
Particularly, make sure that all SCSI peripheral are turned on first.
Connecting the Computer (continued)
15
Operation
Operation
Before Printing
This section describes the following operations that must be made prior to starting
printing after mounting the paper tray and paper cover on the printer and making
the necessary connections.
• Loading an ink ribbon cartridge (see the below)
• Loading paper (see page 18)
Once the above operations have been completed, there should be no need to repeat
them during routine printing. Perform them only when absolutely necessary.
Loading an Ink Ribbon Cartridge
To make printouts, an ink ribbon cartridge and paper (which are compatible) must
be loaded. (see “Ink Ribbon Cartridge and Paper” page 22)
Use the ink ribbon cartridge and print paper (supplied) to check if the printer
functions properly.
Notes
• Use only ink ribbon cartridge and paper that are designed for use with this
printer. Failing to do so is likely to result in unsatisfactory printing or
malfunctions.
• When you replace the ink ribbon cartridge while you are operating the printer, do
not turn off the printer power. Turning off the power will cause the image stored
in the memory to be lost.
1
Open the front panel by pulling the front panel top toward you.
Continue to next page m