2. Scratches
Scratches can be removed using a cutting type of polish. Amutec recommend Farecla P315 and P615
cutting compounds for this process. (This material should be used in conjunction with the
manufacturer’s instructions). This material is available through Amutec or any good automotive
supplier
3. Full
Refurbishment
Deep scratches can be removed by using a wet/dry finishing paper. In most cases a 1000 grit should be
used. Very deep scratches can be removed with 600 grit paper. In both cases use with plenty of water.
After rubbing and drying, the fibreglass will look very dull. The gloss surface can be recovered by
polishing using Farecla P315 and P615 with water and preferably a high speed buffing wheel
(approximately 1800rpm). Amutec recommend Farecla G mops for high speed buffing
Holes in Fibreglass
Small holes in fibreglass caused by vandalism etc. can be filled using car body filler available from
any good automotive outlet. This should be rubbed down to a smooth finish using 600 then 1000 grit
wet/dry finishing paper. When completed, these holes can be painted with touch up paint (see paint
pantone reference sheet). If any fibreglass damage causes a weakening of the fibreglass structure,
manufacturer’s advice should be sought prior to carrying out any repair work
Care of Painted Parts
The characters on the toys can be maintained by the following method:-
Day to Day Cleaning - clean with a damp cloth. In the event of damage to paintwork this can be re-
touched using Amutec touch up paint. Please state colour required.
Never apply thinners to the painted surfaces
Touch up paints are available from the manufacturer
CARE OF MECHANICAL PARTS
The mechanism used on all Amutec rides is designed for low maintenance. Whenever the ride is
stripped for refurbishment check the following:-
1.
condition of 'V' belt
2.
tightness of pulleys
3.
lubrication in bearings
4.
tightness of nuts and bolts
CARE OF ELECTRICAL PARTS
Check condition of earth point
Check the cable for signs of wear every time the machine is emptied (maximum of 1 month)
Check the fuse rating is correct and the mains plug is in good condition every time the machine is
emptied (maximum of 1 month)
Check the condition of the earth bond and earth leakage using a calibrated portable appliance tester
every six months
Carry out full electrical inspection every year (see pages 8/9)
Chuck ‘E’ Cheese Black & White Photo Ride Page 11
