Ad
v
a
n
ced
Adjus
tmen
ts a
nd Se
ttings
39
GB
• SIDE/LOW
Select if the location of your surround speakers
corresponds to section
A
and
C
.
• SIDE/HIGH
Select if the location of your surround speakers
corresponds to section
A
and
D
.
• BEHD/LOW
Select if the location of your surround speakers
corresponds to section
B
and
C
.
• BEHD/HIGH
Select if the location of your surround speakers
corresponds to section
B
and
D
.
* This setup item is not available when the surround
speaker parameter is set to “NO” (page 19).
Tip
Surround speaker position is designed specifically for
implementation of the Cinema Studio EX modes.
For other sound fields, speaker position is not so
critical. Those sound fields were designed under the
premise that the surround speakers would be located
behind the listening position, but presentation remains
fairly consistent even with the surround speakers
positioned at a rather wide angle. However, if the
speakers are pointing toward the listener from the
immediate left and right of the listening position, the
surround effects becomes unclear unless set to “SIDE”.
Nevertheless, each listening environment has many
variables, like wall reflections, and you may obtain
better results using “BEHD” if your speakers are
located high above the listening position, even if they
are to the immediate left and right.
Therefore, although it may result in a setting contrary
to the above explanation, we recommend that you
playback multi channel surround encoded software and
select the setting that provides a good sense of
spaciousness and that best succeeds in forming a
cohesive space between the surround sound from the
surround speakers and the sound of the front speakers.
If you are not sure which sounds best, select “BEHD”
and then use the speaker distance parameter and
speaker level adjustments to obtain proper balance.
x
SP CROSSOVER > XXX Hz
(Speaker crossover frequency)
Initial setting: 100 Hz
Lets you set the bass crossover frequency of speakers
set to “SMALL” in the SPEAKER SET UP menu. You
can adjust from 40 Hz to 160 Hz in 10 Hz steps.
x
OUTPUT (Preout downmixing)
• ALL ON
Lets you output the sound from both SPEAKERS
and PREOUT jacks. (All downmixing is performed
by DSP.)
• FRONT SP OFF
Lets you turn off the sound output from front
speakers and perform the analog downmixing. Select
this when you use this amplifier as a preamp for front
speakers only.
• PREOUT ONLY
Lets you output the sound from PREOUT jacks and
not output from SPEAKERS jacks (analog
downmixing is performed). Select this when you use
this amplifier as a full-channel preamp.
Advanced SURR SET UP menu
parameters
When “MENU EXPAND” is set to “ON”, all of
the following parameters are displayed and
adjustable.
See page 32 for the SURR SET UP menu
adjustments. Initial settings are underlined.
B
B
A
A
100˚
120˚
60
30
C
D
C
D
continued
Summary of Contents for TA-DA9000ES
Page 55: ...Additional Information 55GB ...
Page 59: ......
Page 60: ...Sony Corporation Printed in Japan Printed on 100 recycled paper ...
