Ge
tting Star
te
d
19
GB
• NO or MIX
If you did not connect a center speaker, select
“NO” or “MIX”. When set to “MIX”, the
sound of the center speaker can be output
from the front speakers without deteriorating
the sound quality. For details, see “MIX
SCALING” in the CUSTOMIZE menu
(page 37). The sound of the center channel
will be output from the front speakers.
When the multi channel input is selected,
analog downmixing is performed. Whether
the setting is “NO” or “MIX”.
x
SURROUND SP-A
(Surround speaker-A)
x
SURROUND SP-B
(Surround speaker-B)
The surround back speakers are set to the same
setting.
• LARGE
If you connect large speakers that will
effectively reproduce bass frequencies, select
“LARGE”. Normally, select “LARGE”.
However, if the front speakers are set to
“SMALL”, you cannot set the surround
speakers to “LARGE”.
• SMALL
If the sound is distorted, or you feel a lack of
surround effects when using multi channel
surround sound, select “SMALL” to activate
the bass redirection circuitry and output the
surround channel bass frequencies from the
sub woofer or other “LARGE” speakers.
• NO
If you did not connect surround speakers,
select “NO”.
Tip
When the SPEAKERS SURROUND switch is set to
A+B, the settings for surround speaker-A are also set
for surround speaker-B.
x
SURR BACK SP
(Surround back speakers)
When the surround speakers are set to “NO”, the
surround back speakers are also automatically
set to “NO” and the setting cannot be changed.
• DUAL
If you connect two surround back speakers,
select “DUAL”. The sound will be output to a
maximum of 7.1 channels.
• SINGLE
If you connect only one surround back
speaker, select “SINGLE”. The sound will be
output to a maximum of 6.1 channels.
• NO
If you did not connect surround back
speakers, select “NO”.
Tip
The “LARGE” and “SMALL” settings for each
speaker determine whether or not the internal sound
processor will cut the bass signal from that channel.
When the bass is cut from a channel, the bass
redirection circuitry sends the corresponding bass
frequencies to the sub woofer or other “LARGE”
speakers.
However, it best not to cut them, if possible. Therefore,
even when using small speakers, you can set them to
“LARGE” if you want to output the bass frequencies
from that speaker. On the other hand, if you are using
a large speaker, but prefer not to have bass frequencies
output from that speaker, set it to “SMALL”.
If the overall sound level is lower than you prefer, set
all speakers to “LARGE”. If there is not enough bass,
you can use the equalizer to boost the bass levels. To
adjust the equalizer, see page 34.
x
FRONT XXX meter
(Front speaker distance)
Initial setting: 3.0 meter
Lets you set the distance from your listening
position to the front speakers (
A
). You can
adjust from 1.0 meter to 7.0 meters in 0.1 meter
steps.
If both front speakers are not placed an equal
distance from your listening position, set the
distance to the closest speaker.
When placing only one surround back speaker
30˚
30˚
100˚-120˚
100˚-120˚
A
A
continued
Summary of Contents for TA-DA9000ES
Page 55: ...Additional Information 55GB ...
Page 59: ......
Page 60: ...Sony Corporation Printed in Japan Printed on 100 recycled paper ...
