2-28
SVT-RA40/RA168
3-15. Wheel Gear 2, Main Cam and OPT
Pinch Relay Gear
1.
Refer to Section 3-2 and remove the mechanism unit.
When you do this, make sure the mechanism is in
EJECT mode.
2.
Remove the clamp
1
, then remove the wheel gear 2
2
.
3.
Remove the washer
3
, then remove the main cam
4
.
4.
Remove the clamp
5
, then remove the OPT pinch
relay gear
6
.
Assembly Notes:
1.
Apply grease (VHJ-0100) to the shafts
7
,
8
and
9
,
to the teeth of the main cam
4
, and to the all over the
cam groove of main cam
4
.
2.
When fitting the OPT pinch relay gear
6
, align it in
A
B
order as shown in Fig. 3-15-2. The alignment of
the part
B
is shown in Fig. A. Position the teeth of the
OPT pinch relay gear
6
so that the sixth tooth space
left of part
A
is aligned with the triangular mark on
the pinch cam gear
0
. After aligning part
B
, refer to
Section 3-9-2 and check the positioning of the OPT
pinch relay gear, the pinch cam gear and the pinch lift
cam.
3.
Align the hole in the crescent slide
!-
with the hole in
the mechanism chassis, as shown at point
C
in Fig. 3-
15-2 (refer to Section 3-16 and see the holes
6
and
7
in Fig. 3-16-1).
4.
When fitting the main cam
4
, position the OPT pinch
relay gear
6
and the front rack gear
!=
as shown at
points
D
and
E
respectively in Fig. 3-15-2.
5.
When fitting the gear wheel 2
2
, position the main
cam
4
and the wheel gear 1
