54
Connecting the Projector
Chap
te
r 2
Pr
epa
ra
tio
ns
HDCP (High-bandwidth Digital Content Protection) DVI-
D signal can also be input when the input signal with
specified resolution is input from LKRI-005.
For details, refer to the Operating Instructions of LKRI-
005.
• According to the input signal type, set [Signal Mode] on
[Input Source] in the PICTURE CONTROL window of
the SRX Controller. (page 59)
• When an extension cable is used, the signal may not be
input correctly due to signal reduction.
• If you input 10-bit signals from a DVI-D connector only
(10-bit single mode), a DVI cable compatible with the
Dual-link is required.
Connecting HD-SDI Equipment
Install the optional LKRI-003 HD-SDI input board inside
the projector and connect HD-SDI equipment to the
connectors on the installed input board.
When the LKRI-003 is attached to the projector, select the
type of signal with [Signal Mode] of [Input Source] in the
PICTURE CONTROL window. For Single-link input,
select [YPbPr] or [YPbPr FULL]. For Dual-link input,
select [RGB] or [RGB FULL].
For details, see page 59.
Connecting HDMI Equipment
You can connect HDMI equipment by installing an
optional LKRI-006 input board inside the projector. For
details, contact your dealer or your local Sony
representative.
Notes
DVI-D connector
AUX connector
DVI cable
(not supplied)
Computer
Note
HD-SDI connecting cable
(not supplied)
HD-SDI equipment, etc.
to HD-SDI output
