45
Location and Function of Controls
Chapt
er 1 Ov
er
vie
w
b
SCREEN CONTROL window
For details, see “SCREEN CONTROL window” on page
45.
c
Information window
Location:
Shows the installation location of the projector
that was set in the SETTING window.
Name:
Shows the name of the projector that was set in the
SETTING window.
Operation Timer:
Shows the total operating hours (H) of
the projector.
indicator:
The bar indicator and the value (%) indicate
the proportion of elapsed usage time to the
recommended time between replacements.
Warning Info:
Displays an error message if there is any
warning information on the projector. The same
message is displayed in the STATUS MESSAGE
window at the rear side of the projector.
d
POWER ON/STANDBY (
?
/
1
) buttons and
POWER indicator
Click [ON] to turn on the projector when the MAIN and
LAMP indicators at the rear of the projector are lit in red.
Both indicators and the POWER indicator on a computer
turn green, and you can operate the projector with the SRX
controller on the computer.
To turn off the projector, click [STANDBY] then click
[OK] in the displayed confirmation window. The projector
enters standby mode, and the indicator flashes green. Even
in standby mode, the fans continue to run to reduce internal
heat. When the fans stop running, the MAIN and LAMP
indicators light in red.
e
FUNCTION 1 to 7 radio buttons
Register the data set or adjusted in the Control Function
Menu windows to these buttons, and recall it later to
project an image with that setting.
The setting items that can be registered are as follows:
• [INPUT SELECT], [MASKING ADJUST] and [CUT
OFF] settings in the SCREEN CONTROL window
• [Input Source] and [Signal Adjust] settings in the
PICTURE CONTROL window
• [Color] settings in the COLOR/FRAME window
• [ELECTRIC V SHIFT FUNCTION], [ELECTRIC H
SHIFT FUNCTION], [SQUEEZE], [PROGRESSIVE
DISPLAY MODE], [LAMP POWER] settings, [LENS
CONTROL] settings when the optional lens equipped
with zoom/focus memory function is installed, and [3D
Gamma Select] and [Position Adjust] of [SINGLE 3D
ADJUST] when 3D images are projected, in the
INSTALLATION window
For details, see “To register the settings that have been
adjusted” on page 58.
f
Adjustment/setting window
Clicking the window select button switches the window
for the adjustment and setting.
The PICTURE CONTROL, COLOR/FRAME and
INSTALLATION windows can be displayed.
For details on each window, see “Adjustments and
Settings Using the SRX Controller” on page 58.
g
Window select buttons
Open the window with the items you want to set or adjust.
SCREEN CONTROL window
a
INPUT SELECT radio buttons
Selects the input signal you want to project on the screen.
Input A:
Selects the signal input from the connectors on
the preinstalled input board in the INPUT A section.
Input B:
Selects the signal input from the connectors on
the optional input board installed in the INPUT B
section.
Input C:
Selects the signal input from the connectors on
the optional input board installed in the INPUT C
section.
Input D:
Selects the signal input from the connectors on
the optional input board installed in the INPUT D
section.
Quad-screen Mode:
Selects when you project pictures
from each input sources from INPUT A to INPUT D
on one screen.
Single 3D buttons:
Used for projecting 3D images. For
details, contact your dealer or your local Sony
representative.
b
MASKING ADJUST section
You can mask the areas of unnecessary portions of the
screen.
1
2
4
5
1
2
3
4